Logo

B0381 Engine Code Repair

Meaning of B0381 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B0381 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B0381 code is occuring now you should check B0381 repair processes.
Now don't ask yourself; What should you do with B0381 code ?
The solution is here :

B0381 Possible Solution:

B0381 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

B0381 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

3
Manifold Absolute Pressure/Barometric Pressure Circuit High Input

8
Cylinder 10 Contribution/balance Fault

1
Shift Solenoid E Performance or Stuck Off

Regarding the B0381 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B0381 OBD-II Diagnostic Body (B) Trouble Code Description

B0381 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For B0381 Code

The reason of B0381 OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input.

B0381 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.